Logo

U0465 Engine Code Repair

Meaning of U0465 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U0465 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U0465 code is occuring now you should check U0465 repair processes.
Now don't ask yourself; What should you do with U0465 code ?
The solution is here :

U0465 Possible Solution:

U0465 Engine

Excessive air inflow can be caused by a vacuum leak, a dirty sensor or, an exhaust gas recirculation valve not closing properly. If the problem is not enough fuel, the culprit may be dirty injectors or fuel filters, a weak fuel pump or a leaky fuel pressure regulator. The lean fuel mix error may be accompanied by rough idling, engine misfires, hesitation during acceleration and overall poor engine performance.

U0465 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

4
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent

6
Cylinder 1 Injector Circuit Low

5
Timing Reference High Resolution Signal A Too Many Pulses

Regarding the U0465 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U0465 OBD-II Diagnostic Network (U) Trouble Code Description

U0465 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For U0465 Code

The reason of U0465 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

U0465 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.